A Novel Continuous Extrusion Process to Fabricate Wedge-Shaped Light Guide Plates

A Novel Continuous Extrusion Process to Fabricate Wedge-Shaped Light Guide Plates

Blog Article

Backlight modules are key components in thin-film transistor liquid crystal displays (TFT-LCD).Among the components of a backlight module, the light guide plate (LGP) plays the most important role controlling the light projected to the eyes of RF/Antenna Cable users.A wedge-shaped LGP, with its asymmetrical structure, is usually fabricated by an injection proces, but the fabrication time of this process is long.This study proposes a continuous extrusion process to fabricate wedge-shaped LGPs.This continuous process has advantages for mass production.

Besides a T-die and rollers, this system also has an in situ monitor of Graduation Tassel Photo Charm the melt-bank that forms during the extrusion process, helping control the plate thickness.Results show that the melt bank has a close relationship with the plate thickness.The temperature of the bottom heater and roller was adjusted to reduce the surface deformation of the wedge-shaped plate.This continuous extrusion system can successfully manufacture wedge-shaped LGPs for mass production.